PRINTED CIRCUIT BOARD
1. Turn off power to Load Monitor
2. On the Main Printed Circuit Board cut off completely 4 (Four) jumpers PJ34
     PJ33-PJ30-PJ29. These jumpers can be found approximately in the center of
     PC Board marked for the Reversa Load Module to be set over them. Refer
     to drawing Fig. 5 in the Installation Manual or the Web Site Installation
     Manual.
3. Install Reversa Load Module TLD-425. Follow white arrow on PC Board
     and match up with black arrow on Reversa Load Module for proper pin
     alignment. Push down the Module into the PC Board. After Reversa Load 
     Module has been inserted, screw down using the screw provided.  Make 
     sure all shipping material is removed from underneath the Reversa Load
     Module before installing.    

MOUNTING SWITCH
1. Drill a 1/4 inch hole on the right side of the Load Monitor box, two inches
     from the top.
2. Insert switch into hole with wires on the inside of the box. Secure
     tightly with the lock nut and star washer provided.
3. Adhere “reversa Load” label above switch.

INSERTING WIRES WITH PINS TO CONNECTORS ON PC BOARD
1. Female pin from switch is inserted into connector #3—PIN #19
     (Top left side on PC Board).
2. Male pin from switch is inserted into connector #1—PIN #21
     (Bottom left side on PC Board).
3. Use white wire tabs to route wires along the inside top of box.